#Cisco asa firepower gns3 setup firesight how to#
#Cisco asa firepower gns3 setup firesight install#

#Cisco asa firepower gns3 setup firesight how to#

If you did not register devices during the initial setup page, read this document for instructions on how to register a device to a FireSIGHT Management Center.īefore you can use any feature license on your appliance, you need to enable it for each managed device. A default Health Policy is provided but needs to be applied to any managed devices. To configure or Apply the Health Policy navigate to Health > Health Policy. The Health Policy is used to configure how managed devices report their health status to the FireSIGHT Management Center. A default System Policy is provided but needs to be applied to any managed devices.

To configure or Apply the System Policy navigate to System > Local > System Policy. The System Policy specifies the configuration for Authentication Profiles and Time Synchronization between the FireSIGHT Management Center and managed Devices. If you did not receive a license, contact the Sales Representative of your account. Navigate to the following page: System > Licenses.

#Cisco asa firepower gns3 setup firesight install#

If you did not install licenses during the initial setup page, you can complete the task by following these steps: The detection mode and other options you choose during registration determine the default interfaces, inline sets, and zones that the system creates, as well as the policies that it initially applies to managed devices. On this page, you can also register a device to the FireSIGHT Management Center and specify a detection mode. Any feature licenses can also be installed at this point. You can optionally configure recurring rule and geolocation updates as well as automatic backups. On this page, you must change the admin password, and can also specify network settings such as Domain and DNS servers, and the time configuration. On your FireSIGHT Management Center, you must complete the setup process by logging into the web interface and specifying initial configuration options on the setup page, depicted below. This guide assumes that you have carefully read the FireSIGHT System Installation Guide. This document is a supplement to the FireSIGHT System Installation Guide. After you reimage a FireSIGHT Management Center or a FirePOWER Device, you need to complete several steps to make the system fully functional and to generate alerts for intrusion events such as, installing license, registering the appliances, applying health policy, system policy, access control policy, intrusion policy etc.